Bevel gear units

Product concept

Bevel gear units are favoured when unfavourable installation conditions necessitate a direction change in the transmission.

The bevel gear sets have spiral toothing and are manufactured from alloy case-hardened steel. All gear unit housings are cuboid in shape, are machined on all sides and also have mounting holes on all six sides. Additionally there is a centring fit.

Advantages and features

6 sizes from 88 to 260 mm edge length
4 standard transmission ratios from 1:1 to 4:1
Special transmission ratios upon request
Drive torques up to 2,400 Nm

Model range

The gear units are available with a single sided or double sided drive shaft as well as with a hollow shaft. Gear units with additional, even three dimensional shaft branches are likewise available.

Type W: Gear unit with free input shaft
Type MW: Gear unit with motor flange and coupling for IEC motors

Customer specific adjustments

In many cases, gear units are also matched to the specific guidelines of individual requirements, e.g. as a servo version with low backlash toothing or as a stainless steel version for use in industries with stringent hygiene and cleaning guidelines (foodstuff, pharmaceutical and chemical industries). Further information can be obtained > here.

Technical information

If required please use this
> direct link to power ratings and drawings.

(It may take a certain time to open the PDF files according to the speed capabilities of your internet connection.)

Application example

Striker adjustment on transfer press (car industry)